Download Complete GCD Zoning Requirements General Commercial District Zoning Setbacks (as taken from the Zoning Ordinance) GCD  Dimensional Requirements. Unless otherwise specified elsewhere in this ordinance, uses permitted in the GCD Zoning District shall be required to conform to the following standards: Table 2.8 GCD Dimensional Criteria Minimum Lot Area: 6,000 square feet Minimum Lot Width: 50 feet @ the building line Setbacks: Minimum Front Setback: 30 feet* for local roads 40 feet* for collector roads Minimum Side Setback 6 feet* for residential uses 10 feet * for non-residential uses Minimum Rear Setback: 15 feet* for residential uses 6 feet* for non-residential uses Maximum Building Height: 50 feet* (except upon Fire Chief's written approval with conditions stated therein.) Maximum Impervious Surface Ratio 0.92 Maximum Residential Density (2) 7.0 Maximum F.A.R. (Non-Res. Only) NA * Front setback may be used for parking and service drives but must remain unobstructed by structures or buildings, and must be designed in conformance with Article III, Off-Street Parking and Loading, if used for parking. For exceptions to this requirement, see General Supplementary Provisions. ** Rear setback may be used for parking and service drives but must remain unobstructed by structures or buildings, and must be designed in conformance with Article III, Off-Street Parking and Loading, if used for parking. For rear yard requirements pertaining to double frontage lots see General Supplementary Provisions.